Attention! Input results shown will be +/- 10% from middle value. Hint: The closer your min and max inputs are, the more accurate your results will be!

Attention! Input results shown will be +/- 10% from middle value. Hint: The closer your min and max inputs are, the more accurate your results will be!

Attention! Input results shown will be +/- 10% from middle value. Hint: The closer your min and max inputs are, the more accurate your results will be!

Attention! Input results shown will be +/- 10% from middle value. Hint: The closer your min and max inputs are, the more accurate your results will be!

Conical or Tapered Spring Part Number System - In Inches

The Spring Store Part Number System For Conical Compression Springs in Inches

P

Part Number

CC

Conical Compression Spring

095

Wire Diameter

-640

Small Outer Diameter

-1000

Large Outer Diameter

-7000

Total Coils

-MW

Material Type

-1500

Free Length

-CG

End Type

-N

Finish

-IN

Unit of Measure

The Spring Store By Acxess Spring Part Number System In Inches For Conical Compression Springs

We have developed an easy stock spring part number system using the actual dimensions of the spring. This part number system for springs was developed to facilitate the creation and understanding of part numbers for springs. By using the actual dimensions of the spring in the spring part number we have made our part numbers for springs simple, but yet descriptive of the actual spring measurements in real time. Our part numbers consist of a series of numbers to describe each individual spring. Each part number is separated by hyphens to indicate different dimensional characteristics of a spring. Each series describes a different dimension. Below you will find a breakdown explanation of how The Spring Store part number system works for conical compression spring in inches.

  • The letter P stands for Part Number
  • The letter CC stands for Conical Compression Spring
  • The first series of numbers indicates Wire Diameter=WD
  • The second series, following the first hyphen, indicates Small Outer Diameter=SOD
  • The second series, following the first hyphen, indicates Large Outer Diameter=LOD
  • The third series, following the second hyphen, indicates Total Coils=TC
  • The fourth series, following the third hyphen, indicates Material Type
  • The fifth series, following the fourth hyphen, indicates Free Length=FL
  • The sixth series, following the fifth hyphen, indicates End Type
  • The seventh series, following the sixth hyphen, indicates Finish
  • The eighth series, following the last hyphen, indicates Unit of Measure Inches=IN

Please look at the part number example below for a further explanation.

Conical Compression Spring Part Number Example in Inches:

PCC095-640-1000-7000-MW-1500-CG-N-IN

  • P=Part Number
  • CC=Conical Compression Spring
  • 095=0.095 Wire Diameter=WD
  • 640=0.640 Small Outer Diameter=SOD
  • 1000=1.000 Large Outer Diameter=LOD
  • 7.000=Total Coils=TC
  • MW=Material Type
  • 1.500=Free Length=FL
  • CG=End Type
  • N=Finish
  • IN=Unit Of Measure Inches

Nomenclature:

Material Type: BC=Beryllium Copper, HD=Hard Drawn, MW=Music Wire, OT=Oil Tempered, PB=Phosphor Bronze, SST=Stainless Steel

End Type: C=Closed Ends, CG=Closed and Ground Ends, O=Open Ends

FinishBO=Black Oxide, GI=Gold Irridite, N=None, Z=Zinc

Unit of Measure: Inches=IN